would this apply to any k manifold or is it only worth wile on the rbc
With moving the MAP sensor from the TB onto the mani(alot smoother map signal) the wire harness loops out over the mani, like this
I made a small plate that rotates and mounts the MAP sensor to this.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
would this apply to any k manifold or is it only worth wile on the rbc
Only the RBC mani, the PRB and PRC do not have a provision for mounting the MAP on them, they are on the TB with those.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
ah ok that makes sense
Cool. A little less stress on the wiring i suppose. What does the plate look like?
Formerly known as Plainol2k2si
It is a simple "L" bracket made from some scrap sheet steel laying around the garage.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
I like the Duel mapsensors people were runing, combined they could get 20 psi...... ROFL.
haha just kidding.
Awesome mod ill show this to my Eg friends that have this intake mani
In the second pic you can see the simple metal plate I made to retain the rubber plug that comes with the Karcepts adaptor.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks