i have never heard of Baer Decela Rotors. do you have a picture by chance? i would like to see what they look like.
Wilwood has some nice setups. i would definately look into them.
I currently have the Baer Decela slotted and cross drilled rotor oe upgrade right now.
I'm looking for an upgrade for the rear with the similar look.
I know the front does 80% of the braking.
Does anyone know a brand that carries at something similar for the rear or should I just be gay and get a OE rotor.
Don't have the cash right now for a big brake upgrade and I do not run my wheels all year long since Minnesota winters suck.
Any suggestions
i have never heard of Baer Decela Rotors. do you have a picture by chance? i would like to see what they look like.
Wilwood has some nice setups. i would definately look into them.
EPHATCH.COM 4 LYFE!! OFF THA CHAIN KREW #1
udontknowjack's mom was here....twice!
UPDATED SITE INFO!
Want to become a Site Sponsor? Click Here!
PM for HELP!!
http://www.baer.com/products/oe/img/...rs-image-1.jpg
I will check the wilwood's
Aren't wilwood big brake kits.
Doug you have these don't you
Doesn't look like they have the rear either
www.summitracing.com has very affordable slotted cross driller rotors. I believe 75 for the rear pair
if you have aftermarket rotors now and you want an upgrade, but you do not want a big brake setup... then what exactly are you looking for? i see that you want something "similar", but i guess i am confused.
i say save up until you can get a big brake kit.
EPHATCH.COM 4 LYFE!! OFF THA CHAIN KREW #1
udontknowjack's mom was here....twice!
UPDATED SITE INFO!
Want to become a Site Sponsor? Click Here!
PM for HELP!!
Yeah I have Willwood's up front, they dont have anything for the rear..yet.. But just get a set of these for the rears http://www.tirerack.com/brakes/brake...ar=&perfCode=S
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
those are good rotors, i've got them but without the semi-drilled bits
because they use an angle chamfer there are no stress points for heat fractures.
you could look into getting a bigger OE caliper for the rear, I know the type s uses the same rear caliper and rotor but the TL or TSX might have something you could rig up.
The front rotors I have now with slotted and drilled stop great with the hawk hps pads. They are much better than stock but not a big brake upgrade. I was looking for a similar setup for the rear since I purchased the rear from Baer again and their stock number for the 02 ep doesn't fit mine so they are looking into this issue. Big brakes will come later
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks