k24a2 numbers?

[wishbear]

how much you think i can get at whp with a k24a2 swap?

[az-epdrvr]

-K24a2 swapped from TSX -6 speed RSX tranny -CTR LSD -CTR final drive gear -Hondata KPRO ECU -50 degree VTC gear -Toda flywheel -Exedy stage 1 street clutch -DC race header -HKS 2.5" full exhaust -06 SI intake manifold -Hondata intake manifold gasket -Injen MR short ram intake -Enjo motor mounts -CTR red valve cover -Sun Automobile voltage stabalizer

im make about 220whp/175tp with this setup

[socmex7]

^^ how long did it take you to assemble this set up? like to drop it in and stuff..

[wishbear]

im doing like 9 to 1 pistons and rods a2 head a2 tranny not sure if im going to get lsd 8.8lbs flywheel stage 2 clutch jrrh custom 2.5 to stock axle and aem 3inch cai

[dichotomous]

-K24a2 swapped from TSX -6 speed RSX tranny -CTR LSD -CTR final drive gear -Hondata KPRO ECU -50 degree VTC gear -Toda flywheel -Exedy stage 1 street clutch -DC race header -HKS 2.5" full exhaust -06 SI intake manifold -Hondata intake manifold gasket -Injen MR short ram intake -Enjo motor mounts -CTR red valve cover -Sun Automobile voltage stabalizer

im make about 220whp/175tp with this setup

whats your average MPG?

[SP33D FREAK]

im running a high compression k24 with hytech header, 50degree vtc,440cc injectors, kpro, comp stage 4 clutch and Flywheel, hytech cams, RBC, 3in Straight Thru exahust 279hp 222trq dynapack... (MPG 26-33) I also have a TSX 6th Gear on my Type S Transmission which helps Gas Mileage.