Kpro launch control

[4angrybadgers]

who ever said the limiter is to slow I bet you have it set around 4k try over 6k and its fast ass hell. Btw I wouldn't even use it with street tires

The "bounce" is too slow with a heavy load, no matter what RPMs you set it at. And 6k would be way overkill with the torque from the JRSC... I'd have to slip the clutch so much I'd kill it.

[Accordexcpe95]

buliding boost before the launch ftw.

[Guardian]

The "bounce" is too slow with a heavy load, no matter what RPMs you set it at. And 6k would be way overkill with the torque from the JRSC... I'd have to slip the clutch so much I'd kill it.

not if you had slicks, you could launch at wot and dump the clutch, pre loading of course

[4angrybadgers]

not if you had slicks, you could launch at wot and dump the clutch, pre loading of course

I'm not going to spend money on slicks just to make the broken launch control work. Or on a new clutch for that matter... preloading is just as bad as slipping it on the launch.

[talonXracer]

Just so you guys know, bouncing off the revlimiter(especially the launch limiter) no matter what the RPM's are set at, will eventually lead to a broken timing chain and TCT. It is only a matter of time.

Good luck with that.....

[classiccelica]

really? Wow that would suck something aweful.