oo they shall be in and ready for the MDBBQ 09'!!
oo they shall be in and ready for the MDBBQ 09'!!
Go with the Blueprint ultralight rods and a set of typeR pistons with an extra thick ceramic coating on top. Most drivers do not have the patience for forged pistons, they turn the key and start driving right away. If you try that with forged pistons you will wear them out very quickly and score the cylinder walls, forged pistons must be close to operating temps before you start hammering on the engine.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Not retarded at all very very smart in my opinion. I always get my car up to operating temperatures before heading out on my way. It is always smart to get that oil heated up and circulating properly before driving anything. So I guess 9whp is pretty good off just the intake manifold. So was that fifth gear that I saw in your video going 140
Damn so 140 in fifth huh? What can you do in sixth?
never tried lol and 5th wasn't maxed out
Damn I know that was damn beautiful. So what exactly was your setup in that video.
what u see in my sig minus the bcrh, bc exhaust and injem mr cai. i had a jrrh, t1r 63mm catback and an older injen cai...different design. everything else was the same.
Ok damn, who would have thought that newer factory cams and really a factory motor would pull so damn hard. Great job on that man, this would be the perfect build for me living in california with the smog regulations and such. How much do you think I could get the a2 for? Do you have the 4.3 final drive as well.
Its a stock a2 6spd tranny. soon to have the 4.77 final drive tho u could prob. find a2's for aroun 3700 or so.....i got mine with everything about 1.5yrs ago for about 4k and it had about 15k on it
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks