anyone?
Im trying to get this kit installed. i have the lights mounted and most of the wiring done. i just cant figure the last step. at the end of the harness there are 2 loose wires ( a blue one and a black one). where do they go?
anyone?
When we put mine in that i got off ebay the wiring was all jacked up and we had to run the wires ourself to a switch
by any chance, that blue and black wire connected to a harness? If so, disconnect and I'm pretty sure it goes to your fuse panel. Cant remember to be honest, last time I did an ebay kit was awhile ago. Pics would help if anything G/L
I agree it goes to the blue wire goes to the fuse panel and the black wire gets grounded.
it clip or be unclipped from the harness and there is no plug at the other end. its just two loose wires. im trying to get some pics. i should be able to have them up soon.
http://www.handaaccessories.com/civic/sifogs.pdf
go to step #28. u see where the 6 pin connector goes. the black wire goes all day way to da left and blue goes all da way to da ryte. be sure to use electric tape so the wires dont touch anything.
black-> - - - - - -<-blue
u see the red line on the picture, u only need those 2 wires so pull them out of the connectors carefully bcuz ur going to need the pins on each of the wires end to connect to the fuse box.
i got it. it looks fly. thank you guys fr helping, i'll post pics for you guys soon.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks