Need help fixing S2k Button!

[Si-Kotic]

Yes I have spent a lot of time searching today. And I know the thread exists because I had it as a favorite on my old computer before it crashed. But can anyone help me with a picture that shows how to fix the S2K engine start button. If you pull the button apart there's a motherboard on the inside and on the bottom half with the bus lines you can see one bus is blown. In order to fix that in a previous thread someone had a picture of two of the metal "spikes" or prongs sticking up and you have to solder (sp) one prong to another and then a second prong next to the first to another. Could anyone give me the link to that thread or show me which four prongs need to be soldered to fix this button. Thanks in advance.
Here's a picture of my button and you can see the blown bus.

[VegaS10]

Simply use a small piece of wire and solder those two connections back together.

[Si-Kotic]

Thats the point haha I'm trying to figure out which two connections I need to fix.

[VegaS10]

I wish I had ms paint skills.

[black_02_si]

You should just have to solder the 2 points together. as in the Modifided pic.

[Si-Kotic]

Thank you so much thats exactly what i was looking for, I thought it was two connections but after looking at yours it makes sense that its only those two. thanks guys