I was looking around and i don't know what size belt or what manufacture i should go with. Although the k24 is taller, it looks like the Tensioner sits lower then on a k20a2. I will be running AC.
k24a1 bottom end
Tensionor off of a k20a2
Water pump is off of a k20a2.
I would assume i just use a k20 belt right?
The belts and everything are at the same height as the K20. The coolant passageways that everything bolts onto are the same demesions between the K24 and K20. The K24 uses the same dia crank pulley as the A3, so a stock belt should work. It looks like there is a difference because the cylinder walls are taller, obstacle delusion(optical illusion).
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
thank you sure!
Its odd...I did a k24a1 swap into a base rsx 2 months ago and the stock belt would not fit but then swapped a k24a2 into another base rsx yesterday and it fit great?
really? I wonder what thats all about. What two belts did you order? I might pick up both just in case.Originally Posted by davisj3537
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote
Bookmarks