help bump!
Well I recently aquired some Tien Flexs. They are CTR Spec.
I have the front and rear camber kits and am looking into the T1R reverse Pillow tierod ends.
Which ones should I get...the dc5/Jdm ones or the USDM ones?
I kno this is probably answered on here somewhere...but I am very tired and find this to be easier.
Also being a newbie to Suspension(well, everything actually), is there anything else i need in order to throw on these bad boys?
Thanks in advance guys and gals.
~Chris
help bump!
hm im not sure but i think there is only one kind?
According to thier website...there r the two diffrent ones.
I think i am just going to try the usdm ones.
sounds like you are looking for a big drop.....not a good idea.....read up on suspension some.
Oh no...not in Michigan. I was just under the impression that when the install happens that the stock Tie rod ends might not be reusable...so buy replacements just incase. With that in mind i figured to help the steering rack out a bit with the T1R's...since I was already replacing them. Then I started to wonder if the fitment of the CTR-Spec Flex's might not be so compatible with the usdm ends.
on another note, if you have the TEIN Flex, they should have the pillowball upper mounts and you should not need the front camber kit? at least on the RSX they are set up this way, so they should be the same for the EP3 version.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks