Center dash removal?

[Squidward]

Hey all,

I've got an '04 and the light for the vent selector knob (face, feet, defrost etcetera) has burned out. I have acquired the replacement lamps and figured out how to get the lower half of the silver center dash removed, but ran into a little hiccup for the top half. I found the two phillips screws at the bottom, but apparently there are two bolts higher up that I need to remove before the entire top section is free. Anybody know exactly where they are at and how to get to them? Photos would be awesome if anyone photo-documented a radio install. Even a photo of the back of a removed unit would be helpful.

Thanks

[D3R1K]

I am also interested in this. There has to be someone.

Bump.

[Kerby]

here's a good link on how to gain access.
http://www.k-series.com/tech_document.php?id=10

I think you'll need a 90deg screw driver. It really is a pain in the butt to get to. GL.

[Squidward]

Thanks for the link. It's the best info I've gotten yet but it is still not 100% clear to me.

When I do this, I'm going to take pics of EVERY step and make it clear EXACTLY how to do this removal and reinstallation (or how to break your dash, depending on how it goes).

[shanewdude]

Click here for video on how to remove EP stereo, courtesy JPAX. Hope this helps everyone!

Once, I used a combination of socket extensions on my 1/4" drive ratchet to get at the lower bracket screws from the sides (involves taking off more parts to get access). I've also used a stubby screw driver. Good luck; lookin' forward to the pics and DIY!

[holepunch]

here's a good link on how to gain access.
http://www.k-series.com/tech_document.php?id=10

I think you'll need a 90deg screw driver. It really is a pain in the butt to get to. GL.

You can use an 8mm short socket on a 1/4" ratchet also.

[D'sEp3]

Click here for video on how to remove EP stereo, courtesy JPAX. Hope this helps everyone!

Once, I used a combination of socket extensions on my 1/4" drive ratchet to get at the lower bracket screws from the sides (involves taking off more parts to get access). I've also used a stubby screw driver. Good luck; lookin' forward to the pics and DIY!

very helpful