Last edited by dkid15; 04-28-2010 at 07:09 AM.
messa thinks those washers should be alittle bit bigger considering the adjustment they have to hold.
Yes these are todds caster plates. The construction on them is top notch. Lowered at 1.5 inched they should produce an increase of 6 degrees caster. Kerby, these caster plates are all set for maximum caster, the washers your looking at are for camber. Very little is needed to achieve a great setup, i might just need to run a little to fit those 17x9 RPF1's.
Ill be one of the first ep3's with them. Aeucampeu will have them on his CTCC ep3 and Remy at corsport got a set also.
If I'm not mistaken those plates also work with Progress Coils right?
what's Todd's contact info. I might have to give me a set when I switch from HFP to Progress.
Sweetness, looks like a really nice piece. What's the list on these if you don't mind me asking?
They'll work with almost any coil, even an oem strut/spring combo. His name is todd on clubrsx, dont have his email anymore. He does limited production runs at batches of 5. Im one of 10 people with a set as this was his second run.
400 dollars. Sounds steep but is no doubt the way to go if your looking to take full advantage of lowering a car for handling purposes.
sweet, i haven't seen these. how much static camber can you run with these?
Last edited by talonXracer; 09-30-2008 at 06:07 PM.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks