Some of you may have read my post about the build i did on my motor, for the EP3. if not i'll go over it again. the motor consist of:
K20a2 block
Mahle10.5-1 piston's
Blueprint H-beam Rods
stock crank
K24a2 head
Blueprint Dual valve springs
Blueprint Ti retainers
Stock valves
BC Stage 2 FI cams
Polished intake Runners
S/C was sent out for a recon, and rotor housing coating + rotor coat, by the High Speed Lab.
Act ultralight flywheel
Comp Clutch stage 4
i still have a 4in pulley on the charger due to the fact i want to see the boost numbers that the S/C work provides(was told to expect 2-3 psi more than before with the 4 in pulley)
K-pro
And Suja1 In Carol Stream Will be doing the tune.
I am hoping for 300+ numbers with what i have, and plan on going up to a 3.7 pulley, a test pipe, and Water Meth. i even thought about a custom 3.6 pulley but idk.
I have found myself super excited about this, and thought i would share the whole experience with ya'll. I built this from the ground up and will still be modding it as go , so feel free to ask question's, or post opinion's i want to hear them.
Bookmarks