Reply With Quoteyoull be the first phil!
I'm planning on gettin the 6pt auto power roll cage, does anyone have it?
youll be the first phil!
gotta sell my cusco first =)
Are you making the 6 point into a SCCA or NASA legal cage or just for use on the street? I was asking cause I was curious how you will run door bars and a dash bar thats all. I'll probably just sell my auto power race roll bar and upgrade to a custom cage but i was curious what youll be doing thats all.
88crx, for the plates that go in the wheel well and underneath the car DO NOT forget to seal the backing plates in some way. I forgot to and I had to make new ones. I used duplicolor rubberized undercoating, with about 4 coats. 1 year later it still looks and is holding up great.
I have painted the plates already.... and I'm going to goop up the u/s of the plates with RTV sealer so that should seal out any water.
That was your problem right?
I sealed them with that stuff too. I ment the outside of the plates that sit in the wheel well and the bottom of the car. I forgot to paint/ undercoat them. They are just going to get hit with stones, water and dirt outside of the car, so my first set rusted to shit because i did not protect them. I used rubberized undercoating on the second set and it works great.
It would just be surface rust on the plates though, right? No big deal.
They're pretty thick to be rotting from rust!
I really want to get the 4 point. 88crx how much did you pay to have yours powdercoated
Here we go......
Cage all lined up and ready to drill
Carpet cut
driver side panel cut
passenfer side panel cut w/ tape measure
yaaaa dremel and melting plastic lol
wheel well plates all test fitted up
more test fitting
gooping up the plates with RTV sealer (use lots)
after tightening the plates down, perfect amount of sealer seaping out
floor mounting points all done
all done.... now install the full interior just as it was removed, kinda a pain in the ass with the mini jungle gym in the way lol
with the panels and rear seats all installed you cant even see the holes
done!
Last edited by Kumar; 10-08-2008 at 12:17 PM.
that looks so fricken AWESOME!
gigidi gigidi..... all right!
that looks sick!
looks bad ass man!!!!
nicely done!
the 6pt bolt in doesnt go through dash or the sides for the autopower correct? but the weld in does? im using the cage for track and right now i got cusco which i dont trust to do the job
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Bookmarks