OK so i don't have a inner wheel well liner so i decide to copy the Heat sheild used on short ram intakes, now this could've been done alot better but it didnt matter to me i juss wanted something there.
1. I went to Home depot and brought the air duct aluminum that was already split down the middle. Totally cost 3.79 with tax:
2.Create a template for yourself easier to cut and have guidelines in advance:
3.Take dremel and begin to cut out the template you made for yourself:
4.Should look like this at the end:
5. Now if you really don't care you can slap it on like that, but i don't want mine to be so noticeable so i decide to rattle can it black.Ddidn't cost me anything but i already had the cans laying around:
6. Take the shield you made put the intake inside and bend the tabs along the side like so:
7. Tighten it the intake and shield back on and there you go splash guard for $3.50 :
Bookmarks