bump
kl
Last edited by eroxer310; 12-10-2010 at 11:01 PM.
You should be able to take the negative off your turn signal and run it to the positive of the parking lights. Kinda the same way you do the always on side markers
you should look for the 'always on side marker's' DIY.
same principle
Green Crew #7
Please donate and support EPHatch.com: Greenie Status, License Plate Frames, Banner & Small 'ephatch.com' Decals
Was your WTS/WTT/WTB closed? Please read the following: link 1 & link 2
Before starting!!
the brakelight-lamp fitting i used was from a Civic EK, and is bigger then the one that is originaly used for frontside markers.
i used a brakelight-lamp fitting to make that.
includes a bit of wire cutting and reconnection the wires with others though
ive done it on my EK a while ago:D
when connecting it you must be sure what Color of 3 is what.
- Black/Red/Green
Black is ground, Green (thicker then red) is for Braking/Blinking 21watt power, and Red is for Constant 5watt power
you must also look how the lightfitting fits in your turnsignal slot (where you put your lightbulb through), because it's difirent then the original one..
could use a dremel to cut the slot, or maybe you can remove one of 3or4 pins from the ftting
Last edited by Ryu_Dakera; 05-14-2010 at 10:47 AM.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks