I had to remove the plastic cover off the dampner and slot the rail mounts, then the EP rail fit just fine. The pics are with modded 270cc's.
You will likely need different spacers than what i used, but as long as the injectors 'bottom out' in the rail and the 'gap' (seen at the base of the injector at the manifold) in pic 5 is present after everything is buttoned up... then you shouldnt have any leaks.
You are oiling up the o-rings before you install the injectors? It makes it much easier to install the rail with the injectors pre-installed as one unit.
Bookmarks