WOW. i bet this thing can survive a Nuclear winter now!
WOW. i bet this thing can survive a Nuclear winter now!
I was spraying the upper areas today and leaned over and filled the hair with SoundControl, LOL, luckily the stuff cleans up with soap and water!
Also you can really hear a huge difference in the echo when working inside the car, it is no longer present!
Last edited by talonXracer; 07-16-2010 at 09:50 AM.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
How you going to hear if something brakes or if something goes wrong with the car? "Knock on Wood".
It wont be that soundproof, LOL
There are many indicators of potential failure, sound is just one of them, besides the insulation blocks alot of rattles and vibes, not clunking sounds as the piston finds an optional path to follow out thru the side of the block
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Well the interior of the car is completely sprayed now. The sides and roof got 3 coats of SoundControl, and the floor got 2 coats of SoundControl and two coats of the Ceramic Thermal coating. I will put some poly-fill in the void between the inner panel and rear quarter panel. Already the SC has greatly reduced the tone when slapping the quarter panel behind the front doors, it is no longer a bongo drum !
Started running the electrical back where it goes, still have to clean the ground points, then coat them with battery terminal.
Last edited by talonXracer; 07-17-2010 at 12:07 PM.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Here are a few pics that show the progression on the original rust spot.
nasty ! ! !
a little better
looking damn nice!
And this could be topcoated with any one of your favorite flavors of paint!
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Nice work man, very clean! :)
I accept and embrace the ricer in me...
2016 DGM STi
I doubt that anyone could get me to do this again without a rather large amount of gold exchanging hands, unless of course you are a busty red head, LOL (though I already plan on doing the Silverado...)
Alot of the work was repair work, ie blasting and removal of the Dynamat/rust and application of the ChassiSaver. If I was to do it again it would be far quicker(as long as there was limited repair work required). The actual application of the LizardSkin went rather quickly and wouldnt require removal of the old asphalt based deadener. I had helped a buddy do his RSX last fall and it took only two weekends and a few nights during the week.
*****************
Can anyone point me to the DIY for removing the halfway stop on the sunroof, I tried searching and I must be retarded as I cant find the info!
Last edited by talonXracer; 07-18-2010 at 07:29 AM.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
to disable the sunroof autostop, theres a single 2 wire plug thats located closer to the rear behind the sunroof motor its self on the drivers side of the car, just disconnect the clip and your good. The wire looks like its just plugging into a relay almost.
So, you gonna weigh your car after everythings back in and see how much this stuff added??
Holy baby Jeebus! I'm not sure I have words. Wow! Your going to have the quietest interior EVAR!
Christian
Thnx
Weighing it wouldnt tell alot as there is no spare, no seats and custom amp racks, but I would venture a guess at only about 5-10 lbs gain over the stock asphalt stuff if that, but significant improvements in sound quality inside the cab, as well as easier to heat and cool.
It was aout 100 degrees in the garage just now(all closed up) and the CeramicThermal coating felt cool, almost cold to the touch.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Looking nice! That coating has a nice even flat finish, looks very HQ!
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks