Leveling switch and motor pin-out

[talonXracer]

Here is the electrical schematic for connecting the leveler for the CTR headlights.

[Guardian]

What pins do the wires go to on the relay

[VividSI]

i dont think he wants to sell it to me, im gonna try and piece together the components online as soon as i figure out everything i need.

[Supaduck]

just hooked mine up. make sure you have a LOT of wire, almost ran out....also...a lot of splicing/soldering/other stuff required. x.X this took longer than it seems. lol

[Guardian]

Does anyone know where to buy the conectors for switch and motors?

[Guardian]

Or the part #'s

[mage182]

Thanks for this. I've been looking for it for a while.

[talonXracer]

This is the relay hookups
pin
86 - parking light positive
85 - parking light negative
87 - switched, fused, +12vdc
30 - White power wire

[mage182]

This is the relay hookups
pin
86 - parking light positive
85 - parking light negative
87 - switched, fused, +12vdc
30 - White power wire

So the wires coming from the parking lights control the illumination on the switch as well as power to the whole system? It makes sense that the system should only operate when the lights are on, but just wanted to confirm.

[talonXracer]

Yes the parking lights provide the signal to the relay to fire the relay to provide power both the lights on the switch and the power for the actual leveler function.

[jubaque]

Do JDM spec come with the switch?

[VividSI]

I dont know either, i just got the switch and im just having a shop wire it up. I think theres a "vendor" on here that sells it but he will take your money up front and decide 6-12 months later if he actually wants to send you the parts.

[VividSI]

so who can make me a nice harness that i can plug in a factory leveling switch and that doesnt charge $100 like some vendors?

[Supaduck]

you could just do it yourself for maybe 10-20 bucks by following this thread..its not too hard and really just takes a little bit of ingenuity and the right parts from the hardware store. >.>

[VividSI]

well i have the switch on the way from honda so are any of you guys using a connector that actually bridges the pins to the wires or is everyone just hooking the wires directly to the pins on the switch and leveling motors?