Here is the electrical schematic for connecting the leveler for the CTR headlights.
Here is the electrical schematic for connecting the leveler for the CTR headlights.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
What pins do the wires go to on the relay
i dont think he wants to sell it to me, im gonna try and piece together the components online as soon as i figure out everything i need.
just hooked mine up. make sure you have a LOT of wire, almost ran out....also...a lot of splicing/soldering/other stuff required. x.X this took longer than it seems. lol
Does anyone know where to buy the conectors for switch and motors?
Thanks for this. I've been looking for it for a while.
This is the relay hookups
pin
86 - parking light positive
85 - parking light negative
87 - switched, fused, +12vdc
30 - White power wire
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Yes the parking lights provide the signal to the relay to fire the relay to provide power both the lights on the switch and the power for the actual leveler function.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
I dont know either, i just got the switch and im just having a shop wire it up. I think theres a "vendor" on here that sells it but he will take your money up front and decide 6-12 months later if he actually wants to send you the parts.
so who can make me a nice harness that i can plug in a factory leveling switch and that doesnt charge $100 like some vendors?
you could just do it yourself for maybe 10-20 bucks by following this thread..its not too hard and really just takes a little bit of ingenuity and the right parts from the hardware store. >.>
Last edited by Supaduck; 11-01-2011 at 11:38 AM.
well i have the switch on the way from honda so are any of you guys using a connector that actually bridges the pins to the wires or is everyone just hooking the wires directly to the pins on the switch and leveling motors?
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks