noob ques.... car wont start now?

[k3rry]

so i bought k pro from a guy who had a k20a2 and and installed it in the car which still has a k20a3.... all i did i was plug the k pro to see if it would work.... it did and now the i the car doest crank over.... i uploaded the factory PNF kal. still doesnt wana crank..... i put my stock PNF ecu bak in and it starts right up....... is it the ecu??? help... any sugguestions???

[oneglory]

immobilizer?

[Twisted-X]

To elaborate:
Try turning off the immobilizer.

[k3rry]

it ran for 10 mins and then the car shut off and it cranks but wont start..

[k3rry]

To elaborate:
Try turning off the immobilizer.

did that

[thisisagame24]

load a k20a3 cal up and it should work

[k3rry]

load a k20a3 cal up and it should work

did that... cranks but wont start

[thisisagame24]

did you load a base rsx or si k20a3 map? they are a little different.

the only thing that would stop it from cranking are a wrong map or the immobilizer is enabled. its not going to hurt to double check and reload a new map. it takes all of 30 seconds mang

[k3rry]

did you load a base rsx or si k20a3 map? they are a little different.

the only thing that would stop it from cranking are a wrong map or the immobilizer is enabled. its not going to hurt to double check and reload a new map. it takes all of 30 seconds mang

i loaded the si map and same problem.... just went to new cailbrations and clicked on the factory PNF SI map and it the up arrow and the ignition on..... it up loads and i try to start it... something i am doin wrong?? do i have to wait for a lil??

[thisisagame24]

when ever i load a new map it takes a few cranks to turn over...... like 3-5 seconds

and the immobilizer box should be unchecked

and to load it make sure the lighting bolt is clicked on the top and then i use "ctrl + U" to up load the map. i usually do it three or four times as well

[k3rry]

when ever i load a new map it takes a few cranks to turn over...... like 3-5 seconds

and the immobilizer box should be unchecked

and to load it make sure the lighting bolt is clicked on the top and then i use "ctrl + U" to up load the map. i usually do it three or four times as well

im a noob with k pro, didnt kno i had to uncheck the immobilizer box after loading a new map... thanks man

[thisisagame24]

no problem d00d ..... glad we got it working

[usedep3]

thisisagame is one sexy mammajamma

[mugen03]

lol i had the same problem this week

[thisisagame24]

thisisagame is one sexy mammajamma

i try to be