is it a straight swap? and how about the other way around? i searched and could not come up with any answers... i think(key word) i remember reading something a long time ago about a wiring issue...?
is it a straight swap? and how about the other way around? i searched and could not come up with any answers... i think(key word) i remember reading something a long time ago about a wiring issue...?
the turn signal and reverse bulbs/socket/pigtails are different. you will have to change those and then the tail lights will swap over.
Green Crew #7
Please donate and support EPHatch.com: Greenie Status, License Plate Frames, Banner & Small 'ephatch.com' Decals
Was your WTS/WTT/WTB closed? Please read the following: link 1 & link 2
i was down in import alliance, and i guy asked if i wanted to switch taillights, i have a 03 and he had an 04-05, all we did was switch the pigtails of the reverse bulbs
Is it possible to pull the pins out of the old ('04-'05) connectors and use them in the new ('02-'03) ones, or do you have to cut/splice wires?
TIA
Cut and splice is easier thans pullin pins in my opinion
wheres a good place to get 02-03 tail lights?
How would i go about swapping 02-03 headlights into my 05 Ep3? Do i need any extra parts/wiring?
I swapped out my 05' EP3's tailights about 1hr off the showroom floor with a tech at the dealer that drove an 03' EP3, we swapped harnesses and tailights.
1967 Firebird. . . Yeah its alright
Legendary Ephatcher
Why are you guys getting the older model taillight. I think 04-05 models looks much better than older one. Maybe it`s all red that`s why I don`t like it.
I've seen this info a few times but I've never seen the info for the opposite, 04/05 tails in an 02/03 ep3. I did it to my car, switched the tails to the 04/05 tails.
***** You need 04-05 reverse sockets and bulbs. The brake light and socket is the same for both years, you take the 02-03 reverse light socket and connector and pin it to the signal light harness. Then take the remaining male 02-03 signal light connector and shave it down to fit the 04-05 reverse socket. Then pin it to the 02-03 reverse harness. And your done.
^^^ It's a good idea to change the tail light gaskets when doing this.
http://www.afhparts.com/honda/civic-...me=gasket-base
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks