race header or header and test pipe combo with k24a1

**20blksi02** · 09-07-2010, 09:37 PM

Does anyone know what exhaust system setup will fit in a k24a1 swapped ep3? I have heard that a lot of setups will not clear the front sway bar. I would like to have the front swap bar in place but if there is an aftermarket bar that would allow more clearance that would work too. Just let me know what setup you guys are running with success. Also when running a test pipe or RH do the foulers work to fool the downstream O2 sensor (I hate CEL lights)? thnx for any help

**20blksi02** · 09-08-2010, 02:25 PM

no one?

**AUTiger** · 09-08-2010, 02:38 PM

both can be found with searching.

Some say the em2 or 02 si sway bar work with a raceheader. But I don't have personal experience, atleast not until next week. I purchased a k24a1 this morning and it will be delivered to the shop Friday. I have a 2002 ep3 and will be using a krrh and type-s midpipe.

As for the defouler, yes they work to keep a CEL from going off

**mugen03** · 09-10-2010, 07:29 AM

03 ep3 here with a k24a1 stock header connected to a test pipe with a defouler on it....it works i dont have any clearance issues or check engine lights. i noticed a difference but i would say if your going to buy stuff buy a race header instead thats what im saving for.

**Hybrid_Hatch** · 09-25-2010, 09:00 AM

I have a K24a1/K20a2 with a kiddracing header and stock sway bar with no issues, also on hasport mounts.

**AUTiger** · 09-25-2010, 09:08 AM

I haven't had a chance yet to look under the car. There might be a chance that my KRRH is tapping my sway and I am using my stock 02 sway. I know for a fact that the resonator on my type-s midpipe is banging the shit out of the heatshield, so I will be getting under the car soon to fix that and will look at the sway while under the car.