Injen Cold Air Intake

[Silver03EP3]

alright so i can get my hands on an Injen Cold Air Intake for an RSX-S and i wanted to know if i could get this sucker to fit on my ep3...but i have an a3 still

if not oh well :/

[talonXracer]

It can be made to fit, the mount near the filter needs to be "tweaked"

[mp_02si]

Good intake too. Better than my aem soda straw my engine breathes thru.

[Deadphishy]

I love my Injen MR cold air intake.

[darvaz]

I had to use a combination of cable ties and a coat hanger with a little creativity to hold it on. It was meant for a temporary solution but i haven't figured out what to do in place of that.
Also, make extra sure that the counterweight on your shift linkage will clear the intake through all of the gears. I had to cut some plastic from my radiator fan shroud with a dremel to get a fitting angle.

[T_Virus]

I had to use a combination of cable ties and a coat hanger with a little creativity to hold it on. It was meant for a temporary solution but i haven't figured out what to do in place of that.
Also, make extra sure that the counterweight on your shift linkage will clear the intake through all of the gears. I had to cut some plastic from my radiator fan shroud with a dremel to get a fitting angle.

Wow that bad?

[sleepy ep3]

I had an Injen CAI, and I hated it. It sat to close to the ground and the air filter was soaked every time it rained. Even with a Hydroshield it didn't matter. I would never buy another one.