you do not need to. but would be beneficial.
with the RBC manifold and a aftermarket 70mm. TB would you need to bore the manifold ?
you do not need to. but would be beneficial.
EPHATCH.COM 4 LYFE!! OFF THA CHAIN KREW #1
udontknowjack's mom was here....twice!
UPDATED SITE INFO!
Want to become a Site Sponsor? Click Here!
PM for HELP!!
I was told that its actually worst than have the stock TB on as far as performance
you have a swap?
it may depend on the motor setup you have.
EPHATCH.COM 4 LYFE!! OFF THA CHAIN KREW #1
udontknowjack's mom was here....twice!
UPDATED SITE INFO!
Want to become a Site Sponsor? Click Here!
PM for HELP!!
I have a K24a2
Last edited by i02si; 11-28-2008 at 02:23 AM.
guess i coulda saw the big red K24A2 sig. ;-)
i am not sure the comparison of the RBC on a K24 manifolds and what the differences are.
but if you can get more air in there, the better.
EPHATCH.COM 4 LYFE!! OFF THA CHAIN KREW #1
udontknowjack's mom was here....twice!
UPDATED SITE INFO!
Want to become a Site Sponsor? Click Here!
PM for HELP!!
You need to match the inlet and TB size.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks