? are you referring to the supercharger mani or the stock mani?
Just wondering if anyone was running a dc5 manifold instead of an eo3 manifold? If so...what needs to be modified to fit? BTW thinking of going from turbo to sc
? are you referring to the supercharger mani or the stock mani?
Last edited by talonXracer; 10-23-2010 at 06:35 AM.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
I've been running a RSX JRSC manifold for about two years now. There are also a few other members running it (one in Canada and one in Jersey). No problems what so ever. The only reason to realistically run it is if you plan on adding an aftercooler to your setup. If you do not, just stick with the Ep3 JRSC manifold.
Become a Sponsored Member. Only $20 for an entire year!!
Need a service manual for your K-series?
Ep3 Service Manual DC5 Service Manual CL7 Service Manual
hey john did you ever get the auto-tensioner to work with the blower?
I was under the impression that the design of the manifold flowed a bit better than the EP
What is needed to make the RSX mani fit the EP3? I have the EP specific blower currently and if I could swap everything out to the RSX manifold so I could run an aftercooler that would be great!
Also it would be a great time to send the charger to be rebuilt and have the new manifold ported. Should make a good match with my auto tensioner.
Bump... any input on what was modified to make this fit. Im wondering if I went with the dc5 kit what kind of issues I may run into being k24 swapped.
Just a little trimming you could also just bend it a bit, but I just cut a piece out and it fits fine.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks