the switch is to turn the remote start on and off, if you want it to work turn it on, i have the same thing in my car but not sure what the button is for
and did this happen out of no where?
so here is the deal. my car wont start because it dont reconize my key...
so i went to the dealer to reprogram my key chip
suprise! it didnt work
so the guy at the dealer told me it was probably the imobilizer or if i had a remote starter maybe it was that!
so i chek under my dash back home and suprise! there were a power start box and all the wiring for a remote starter with my gray valet key in the box!
here everything
here is the 2nd box with the valet key to jumpstart the imobilizer and a key chain?? wtf
here is all the wiring
imobilizer
and thats a switch and a push buton??? what the hell is that for???
so i unplug enverything and the car wont start again. do i have to plug some of those wire back somewere or i defenatly change the imobilizer (cost 260$ at the dealer)??
thanks guys
the switch is to turn the remote start on and off, if you want it to work turn it on, i have the same thing in my car but not sure what the button is for
and did this happen out of no where?
i tryed with the switch on and it didnt work! and yes it happen out of no where
no one?
is the immobilizer light flashing when you try and start the car? if yes then it should not have anything to do with the alarm/starter and the push button is for programming the remote starter.
I'm from Detroit, we are so gangster even our mayor is in jail
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks