RBC with aftermarket TB

[LOVIN MY EP3]

with the RBC manifold and a aftermarket 70mm. TB would you need to bore the manifold ?

[Tnhatch03]

you do not need to. but would be beneficial.

[LOVIN MY EP3]

I was told that its actually worst than have the stock TB on as far as performance

[Tnhatch03]

you have a swap?

it may depend on the motor setup you have.

[LOVIN MY EP3]

I have a K24a2

[Tnhatch03]

guess i coulda saw the big red K24A2 sig. ;-)

i am not sure the comparison of the RBC on a K24 manifolds and what the differences are.

but if you can get more air in there, the better.

[talonXracer]

You need to match the inlet and TB size.

[LOVIN MY EP3]

guess i coulda saw the big red K24A2 sig. ;-)

i am not sure the comparison of the RBC on a K24 manifolds and what the differences are.

but if you can get more air in there, the better.

lol its okay RBC is really good for top end

You need to match the inlet and TB size.

Time to start looking for a machine shop