anyone..?
what belt do i get for my k24a1/k20a frank build. I am running the k24a1 CP and a type-s water pump and still using the A3 alternator, AC and idler pulley. sorry but i searched and could find anything
I believe you will use the stock belt for the CRV/Element/Accord on that. All the accessory pulley's should be very close to the same diameter and the main difference should be the height difference in the block.
Except now that I write that I'm not sure which vehicle has EPS and which has hydraulic PS. And that will definitely make a difference. Crap.
I talked to Deadphishy about this - he said to use the ep3 belt. I'm running an a2 CP... have you thought about using one of these? Depending on how high you plan to rev you may overdrive your accessories.
You should compare sizes to confirm this but I think the a1 CP and a2 water pump pulley are the same sizes as the stock ep3 ones so an ep belt should work.
I would guess you'll be fine since you're closer to the a3 6800 redline than the a2s 7800
Doesn't hurt to have the smaller CP tho, especially if you plan on redlining often
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks