nice work!
Just did this tonight, but it got too dark to take pics. I'm not sure what it'll look like in the morning, but when I got the handles back in place, they looked great.
Follow this link: http://store.carbonfibergear.com/3m-...on-fiber-vinyl
Choose the 4x8" sample sheet with free shipping. It'll arrive in a few days in a regular envelope in the mail.
It's just enough to cover both interior handles if you angle them on the sheet, so make sure you place them both on there and draw a line between them so you can cut it in half. If you don't know how to remove the plastic door pull inserts, look for a tiny hole at the bottom-back of the pull, and stick a thin, short screwdriver in there. Press forward with the tip of the driver, and the insert will snap out.
Before starting, I used 250, then 400-grit sandpaper to remove some paint and rough up the surface, then cleaned it with mineral spirits.
Then, remove the backing from the vinyl and stick it to the insert. It didn't seem to require soapy water, but a hair dryer is essential for keeping it soft while you work around the handle. Trim it with an X-Acto blade, then re-heat and work around the edges until you're totally satisfied with it. When you're done, pop it back in the door.
Edit: used my flash for pics. I'll get more tomorrow in the daylight if you want.
Last edited by Aaron_in_MO; 11-19-2010 at 05:28 PM.
looks really nice, mine are scratched and this would go perfect with my cf dash kit. Order placed
nice work!
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
nice work
i have done this to my interior as well, i love it
^ that is not paint
it is wrapped matte black vinyl
A urethane enamel will work fine on those handles, I like to use DuraCoat as they also have flat, satin and gloss clears.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
looks good.
hatt! I did this a long time ago. I forgot if I sprayed clear coat or the spray for wood finishes.
i just did mine tonight, turned out great and looks perfect with the cf dash kit....now i just wanna do something with the handles and lock button
Looks awesome for sure. Too bad i can never figure out how to get these the door handle or the lock button outt:(
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks