is the camshaft sensor code for phase gap?
Hii im from Dominican Republic i own de Only EDM EP3R in the country !!
I have some problems ... My car have CEL light on ... The codes are CAMSHAFT SENSOR ... O2 PRIMARY SENSOR.... Plus I have a PRC Ecu On (i think this is the Problem) The old owner Had KPRO but He sold the EP with PRC (NOT THE FACTORY PRA) the car is Very slow IDK what to do Cuz Its a EP3R it has to Run Like a Champ Help Me on this One !! One Pic Of the car ... Sorry for quality is PHONE PIC and sorry for my bad english (EP3R EDM FACTORY ENGINE IS K20A2)
Last edited by nesty_2; 01-06-2011 at 10:05 PM.
is the camshaft sensor code for phase gap?
The PRC ECU will not control the engine properly, the stock ECU should be installed or better yet get Kpro.
The PRC uses the jdm NARROW band o2 sensors, EVERY OTHER market uses wide band o2 sensors.
Camshaft position CEL usually indicates jumped cam timing.
Last edited by talonXracer; 01-18-2011 at 06:33 AM.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
Soo the problem is that my engine is out of time ?? what can i do ?? and thanks in advance ! !
Last edited by talonXracer; 12-16-2008 at 08:45 PM.
First off verify the cam/cam chain timing. Then report back.
Install the original stock ECU or a Kpro equipped PRB ECU.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
How can i verify the cam chain timing ?
Ecu then i guess
there is a lot off good machanics in dr I know if u ask around there u will find one that can help u..there is a lot of other ep3s there too
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks