Massachusetts cops. nuff said.
ep3moschini wired one up on his 02-03 tails and got pulled over right away
99.9% of cops will think you have a tail light out
So with the German switch you would need to add a relay inline with the wires to the hatch, and no relay is needed for the FIT switch? Anyone know the pin outs to the fog on the switch assembly?
there was a wire diagram floating around in the ephatch intrawebz that showed the relay and what to plug where in the terminals.
It was also a rough sketch of how everything was wired up. anybody have it stored and can upload it again?
A FIT service manual would give ya all that info, it has been a long time since I metered out the FIT/CRv combo switch, I dont remember what is what.....
Last edited by smoody; 12-21-2008 at 01:49 AM.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
which is ground and power in the EP3 16 point connectorof the left and Right red dots?
i want to see a how to :)
be jealous :P
back from the dead..2 quick questions..1st one, if I did have a UKDM momentary switch, how would I wire it up to a relay?? Would I have to use a latching relay as well as a normal relay?
2nd question
which pin is the power and which pin is the ground?? Is it the red and white wire? or is it the left red dot? or the right red dot? I just got my switch today and really really wanna get my fog wired up.
Last edited by Jukka; 04-27-2011 at 01:23 PM.
Not sure which pins they are, i had that posted up years ago and it seems to have become a victim of purges, LOL
I took the cover off the switch and then broke out the DVM and service manual(there is a small combo switch chart in there) with those and the switch in your hands it is easy as pie figuring out what is what.
IIRC the combo switch provides a ground and not voltage to operate the fog light, that is Honda's normal procedure for operating relays, utilizing the switch on the ground leg or as the ground source.
Last edited by talonXracer; 04-27-2011 at 02:16 PM.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
EDIT: I FOUND IT!...now just need some time to wire everything up and make a how-to along with it.
Last edited by Jukka; 04-27-2011 at 07:58 PM.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks