I bought NRG 2-point seat Harnesses and they are pretty good...Sparco also makes good ones.
What are some good seat harnesses that I can get for my Buddy Club Bucket I just got??? I don't want Takata ones so don't say them!!!!
I bought NRG 2-point seat Harnesses and they are pretty good...Sparco also makes good ones.
my ep is white...
- We can talk numbers all you want, but the bullshit stops when the flag drops...
WTS: 17" beater wheels 4 lug, Dell Studio 1555 Laptop, Volvo Lip, Nikon mount lenses, BuddyClub wing, and more. PM me.
http://www.ephatch.com/forum/showthr...110#post935110
make sure you route yopur belts properly. i believe 15 degree's angle from your shoulder/neck is the rule...
Edit: found pic
my harnesses are mounted properly.
be jealous :P
A lot of people over look CROW harnesses. They are super good quality and are very affordable.
-Rob
Are your mounted to the head rest in the back? Tough to tell in that picture.
Was going to be my suggestion as well.
I've sat it lots of different ones I prefer a wider webbing like 3".Some of them make narrow 2" crap that I didn't really like. If you can get past the green of Takata's they really are nice and easy to adjust. My new Willians are also very nice and comfy, if you can wait long enough to order them in, plus they come in any color you can imagine.
In to find out where CustomX's harnesses are attached.
I've toyed with the idea of going for a harness, but don't want to remove the rear seats if possible.
So, if there's a way, I might be down :D
WTS: 17" beater wheels 4 lug, Dell Studio 1555 Laptop, Volvo Lip, Nikon mount lenses, BuddyClub wing, and more. PM me.
http://www.ephatch.com/forum/showthr...110#post935110
I like my Simpson units. Not JDM at all, but they do the Job!
Your most reliable source for K24 swap help and warrantied/papered K24 longblocks. Serving the K-community since 2004.
The Evolution:
2003 Ep3 - K24A1/K20Z3 Hybrid - currently under the knife
2001 S2000 - Stock and loving it
1987 Buick T-Type WE4 - The BEAST
It is essential that you incorporate a harness bar, there is ABSOLUTELY no safe way to mount the shoulder harnesses in the EP3 without a harness bar ! ! !
If you were to be in an accident with the usual half-assed procedure of routing the shoulder belts through the seat openings under the head rest and then downwards to connect to the chassis, you will be in a world of hurt and probably will never walk or move an arm ever again!
Last edited by talonXracer; 01-28-2011 at 07:24 AM.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks