Well my K20A3 is dead and I'm going to have a K24A1 swapped in. Whats the smallest pulley I can run on the JRSC for boost? I was going to swap the accord crank pulley on my A3 since I'm running the 3.8' pulley to up the boost. I'm not sure if the K24A1 changes things, pardon my ignorance.

My current mods are:

JRSC
3.8" Pulley
440cc Injectors
Injen 3" CAI
KRRH/CRSX RH
Custom 3" Exhaust
K-Pro
Innovative Motor Mounts (All 4)
CC Stage 4 w/Lightweight Flywheel

When the K24A1 is swapped in I will be reusing most of the above and adding:

Rebuilt/Ported JRSC from Stiegemeier
Ported Throttle Body
Crower Stage 2 Cams
AIS Methanol Kit w/11GPH nozzle
650cc Injectors
And if money allows a 6spd trans w/ LSD

What pulley setup should I run to get ~11-12lbs of boost out the M62? I'm looking to crack 300whp. What should the rev limit be? Should I grab a set of supertech valve springs + retainers? Should I add a Hybrid Racing Chain Tensioner? Will the KRRH/CRSX RH fit fine with the K24A1?

What sucks about this whole deal was the day before the motor went I was working out buying a complete rear 03 Cobra IRS for my FD!!! Guess she'll have to wait!

Thanks to those that offer advice!