Im pretty sure you change it under parameters under map, it should give a few other map sensor option and that is one of them
So... I just got a Skunk2 TB and said to myself... HEY!... Why not buy a new map sensor before the old one goes bad... So I went with this one.
So... I'm gonna upload my K24A1 Kal and was wondering what should I plug in for this under MAP?
I chose Replacement MAP Sensor and there are two boxes Scalar & Offset....
What should I punch in?
If a MAP sensors gives the manifold pressure readings, what does it do to have this Hondata Sensor? What advantages do I have with this other than having a cool new HONDATA Sensor? LOL
Last edited by sicivicguy; 02-28-2011 at 09:48 PM.
Im pretty sure you change it under parameters under map, it should give a few other map sensor option and that is one of them
just downloaded kmanager again,.. under map click the replacement map sensor button, andfrom the dropdown click on the 4 bar and eveything should be auto done
And what it does is allow you the kpro software will alow you to read past 10 psi,.. if your not boosted you wasted your money
Last edited by makavelibranded; 02-28-2011 at 09:57 PM.
no i think the only reason those are there is for if you push custom if you bought one they dont have already presetup so you can adjust it
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks