doesn't the top just pop off and isnt the bottom is held in by 3 or 4 phillips head screw?
how to remove it without/minimal damage?
doesn't the top just pop off and isnt the bottom is held in by 3 or 4 phillips head screw?
Green Crew #7
Please donate and support EPHatch.com: Greenie Status, License Plate Frames, Banner & Small 'ephatch.com' Decals
Was your WTS/WTT/WTB closed? Please read the following: link 1 & link 2
not sure, i got an ati gauge pod and i dont wanna scratch up some plastic.
It's easy, take off the 3 philips screws as mentioned before and pull the bottom piece apart. The top piece literally clips on to the bottom piece and slides up and out. I think we got the same gauge pod, I got the autometer one but I think you need to mount it on the OEM cover.
nope not the same. this one has a replacement mold for the top and has (basically) built in adjustable gauges pods, with wire management on the back. i'll post up pics. im not installing it yet, waiting for my gauges to come in.
Last edited by AKEP; 05-28-2011 at 10:20 PM.
That's actually a really nice product. If you don't mind me asking, where did you purchase it? I might as well sell my autometer pod to my friend and buy the Ati pod.
ATI-CVC-EPOD-52
http://www.google.com/search?q=ATI-C...=shop%3A1&aq=f
same part for EM, EP, dc5
took me a while to find it. then i asked about it and someone had it up but the pics were meh. i dont like the a pillar pod and i only need 2 gauges, and this is probably the most sleeper status ones i could find. i'd really like some bezel mounted ones like the DC integras have. something MORE oem looking. but yeah. this is good enough.
Bummmpppppppp =]
bump i wanna see some installed pics!
i painted mine,i think if you just remove the screws from the bottom the top will just pop off then replace it with the new one and reinstall screws.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks