Do you have open loop selected?
Also check what the idle AF is set at(cant remember the tab used, but you can set a target range for closed loop(uses STFT to ignore the calibration))
its at about 20:1, do i just add fuel to the section on the map where the highlighted area is?
i tried this and it didn't do anything, stayed at 20. ?
Do you have open loop selected?
Also check what the idle AF is set at(cant remember the tab used, but you can set a target range for closed loop(uses STFT to ignore the calibration))
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
i'll check it out in the morning.
so i put it in open loop, added up to 30% more fuel and it still sits at 19-20 afr...but when i change the overall fuel trim i do see the changes in closed loop.
On the parameters page, idle tab, what is your target lambda set at?
Then on the kpro kmngr screen hit the "options" tab, then select "settings", then select "lambda overlay" and set the proper target lambda you want.
ALL advice issued with this "Disclaimer"
Tim "the Toolman" Taylor is my HERO ! ! !
"Labor Unions are Domestic Terrorist orgainizations"
14.59:1
lamba overlay looks fine, nothing about idle?
i just noticed that i usually have "follow cam angle" selected and it wasn't, and i remember it not being at 0, so i was looking at the wrong map. lol nub mistake. i'll play with it tomorrow, now that i saw that.
Last edited by AKEP; 07-08-2011 at 05:10 AM.
also, worth mentioning..
make sure your primary o2 is in good working condition.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks