I replied to your PM about this. Hopefully the info helps!
I have a quick question... one of the bearings on my tensioner pulley went bad which caused the pulley to break. I know I can order one from JR but I was seeing if anyone has purchased any others that aren't plastic like the JR one or just one that I could possible buy at a parts store (even if it is plastic) so that I could have my car up and running again before Tuesday? Any and all help is greatly appreciated!
Oh, I have the race kit for my 2002 EP3.
Last edited by Boostin'EP3; 10-22-2011 at 10:37 PM.
I replied to your PM about this. Hopefully the info helps!
Sorry should have posted the answer here as well for any others to reference. You can use an RSX Idle pulley as a tensioner pulley on the EP JRSC setup. It is slightly larger diameter than the one that comes with the kit. This gives you a little more play room with the tensioner bolt, which in turn helps to eliminate belt slippage if you go down to the 3.8" pulley. As far as I have seen it is also a bit cheaper than what JR charges for a new tension pulley.
So this is a better option then the jr tensioner the other day my belt slipped just from a second gear pull wonder if this would help stop it
It is the same manual tensioner, just using the RSX-S idler pulley instead of the one that comes with the JR Tensioner.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks