Looks good, too bad you're on the other side of the country. Though I wouldnt wrap anything on my blue car except maybe some interior pieces.
Last night's project 2003 Celica GT lower center console
Fuckin awesome! I was considering a VC wrap... but leaving the coil pack area natural (beadblasted) and cleared (airbrush). I know VC prep would be critical, but do you think the heat would cause it to peel up?
Cause powercoating is sooo yesterday? LOL
Could i buy a strip off of you to try on my VC? Im thinking epoxy along the edges might keep it down... and the heat might then keep the vinyl taut.
Looks like youre gonna need about 1 yard by 2 feet to have plenty of play room. I would just get a piece from here and use the excess for interior pieces.
It's 5' x 2'.
http://www.ebay.com/itm/3M-1080-Scot...#ht_4280wt_952
I always buy from them. They ship super fast. You'll have it in like 2 days. Good luck. Make sure you keep checking on it after you install it cuz I think it's gonna melt bro.
Sweet! Heck whats the worst... im out $40? lol I figure its worth a shot.
The top of my dash is perfect... no splits or fading, but i wouldnt mind doing the lower sections of the dashboard. The plastics are old and pretty costly to replace (if even available since its a 95 year model), and paint just wears. I have a heat gun (Wagner) and Xacto knives/blades, any other tools you use to fit around curved tight places?
TIA...
Just heat and patience
Sent from my SGH-T989 using Tapatalk 2
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks