Door Window Molding

[dttaz]

Does anyone happen to have the part information for the rubber molding that is under the windows on the driver and passenger doors? Mine is starting to dry up like expected and I would rather keep the flat black rubber look instead of scraping all of the rubber off and have the chrome look.

I have looked on majestic honda to see if i can find the part number but it doesnt point it out very well on the illustrations.

[1st]

91501-S5A-003 CLIP, DOOR MOLDING

http://www.hondapartscheap.com/find-...SILL%20GARNISH

That is the link above. Double check or just call to verify.

[1st]

My info stated is wrong (mybad) looks like that is the clips that hold that molding strip in place. Still searching for correct feedback.

[1st]

67325-S5S-E00 TAPE, R. FR. DOOR SASH (UPPER)
67365-S5S-E00 TAPE, L. FR. DOOR SASH (UPPER)

This has got to be it.

http://www.hondapartscheap.com/find-.../DOOR%20PANELS

[Nickle n Dimin]

#1 & #4 in this link is what i think you are talking about i recently replaced and it makes a world of difference

91501-S5A-003 CLIP, DOOR MOLDING

http://www.hondapartscheap.com/find-...SILL%20GARNISH

That is the link above. Double check or just call to verify.

[dttaz]

Awesome, you guys are the best! Thanks!

[bluedemonep3]

you could always try plasti dip, looks good and you dont have to spend on another set

[whatsvtec]

you could always try plasti dip, looks good and you dont have to spend on another set

hell yes!

[dttaz]

Thats also a good idea! i already ordered the new set though lol

[Nickle n Dimin]

there is a thread here on how to install be careful with the tweeter covers they don't come off so easily i broke 1 lol

[dttaz]

Lol thanks for the heads up, ill try my best not to break anything lol

[blueandgoldep3]

so the verdict was 5 & 6 were the parts he needed? because mine too are becoming worn and id like to replace them as well

67325-S5S-E00 TAPE, R. FR. DOOR SASH (UPPER)
67365-S5S-E00 TAPE, L. FR. DOOR SASH (UPPER)

This has got to be it.

http://www.hondapartscheap.com/find-.../DOOR%20PANELS

[Nickle n Dimin]

molding side sill garnish #1 and #4 the way he described was that the chrome was showing.. where the door meets window on the exterior it is about 3ft long and held by two clips in the diagram. #5 and #6 in your link goes above the window on the door and is not rubber

[dttaz]

there is a thread here on how to install be careful with the tweeter covers they don't come off so easily i broke 1 lol

So i spent a solid hour or so looking for this thread and I couldnt find it, so far i can tell that it is just held in by a couple clips and can be wiggled out with a flathead and some patience, is that right?

[Cheep3]

I'm not sure if our ep3's are the same but I've seen several DIY's for the RSX. I'm assuming ours comes out the same?
http://forums.clubrsx.com/showthread...ht=window+trim