JDM EP3R Service Manual

[usedep3]

I'm trying to make a DIY for JDM EP3R power folding mirrors

Anyone have a copy of the JDM EP3R Service Manual?

I'm looking for something similar to a helms manual.

I need the electrical/circuit diagram for the power folding mirrors.

Let me know if you have any leads on getting a copy of it. Thanks guys!

[usedep3]

bump!

[Kerby]

Did you see this thread?

http://www.ephatch.com/forum/showthr...Type-R-mirrors

[usedep3]

Did you see this thread?

http://www.ephatch.com/forum/showthr...Type-R-mirrors

Yea, I did. That link is a DIY for adding UKDM facelift 'blinker' mirrors onto a USDM ep3. It taps directly into the stalk and doesnt utilize the heated mirror function.

I'm trying to wire up the power folding option found on the jdm ep3r. I haven't been able to source a jdm ep3r specific power folding mirror switch, but I did find one that might be compatible. I need the wiring diagram to figure out which wire is which.

I have found plenty of threads where owners for the switch to work via a relay chain, but I want to be able to use an oem ep3r switch. I think I figured out the part number but I haven't been able to confirm it.

[DA9_GSR]

Is this what you're looking for? ;)

The part number for the JDM EP3R folding mirror switch is:

- 35190-S7A-J11ZB

[DA9_GSR]

I too am slowly putting together JDM EP3R folding mirrors. I acutally plan on removing the entire harness and rewire it like OEM. All the wiring for the mirror movement is identical from USDM to JDM. Being a canadian SiR, I have power heater mirrors. So I will be able to used some wires that are already there. I only have to add two more. You americans have it a little less easy. You'll have to add quite a bit more to make it work.

[usedep3]

Is this what you're looking for? ;)

The part number for the JDM EP3R folding mirror switch is:

- 35190-S7A-J11ZB

I too am slowly putting together JDM EP3R folding mirrors. I acutally plan on removing the entire harness and rewire it like OEM. All the wiring for the mirror movement is identical from USDM to JDM. Being a canadian SiR, I have power heater mirrors. So I will be able to used some wires that are already there. I only have to add two more. You americans have it a little less easy. You'll have to add quite a bit more to make it work.

Thank you sir!

Have you been able to source the switch?

[DA9_GSR]

Thank you sir!

Have you been able to source the switch?

The switch is the last thing I'm looking for. I've tested my EP3R folding mirrors and they work properly. I just need that switch and the wiring begins.

[usedep3]

The switch is the last thing I'm looking for. I've tested my EP3R folding mirrors and they work properly. I just need that switch and the wiring begins.

I'll let you know when I track one down.

I have a switch but it's for an EK9. The switch has a built-in relay, which is similar to the 35190-S7A-J11ZB but would require a rewire. If I can track down a switch, I'll let you know

any chance you have the wiring schematics for the EK9 mirrors? lol