5 Lug Conversion Parts?

[SkareKrow]

Looks like just a few last parts to by just incase. Not sure if my swap is 02-04 or 05-06 (is there a way to check?)

the ball joint is bigger on the 05-06 knuckle to a arm and the hub is bigger also.

¶SK¬

[Bwek]

for the rear I actually only swapped the hub and disc, caliper and everything else it the same, you may notice that you gain positive camber on the front end when you use the type s knuckles I just used camber bolts, but this could be also because i still have stock suspension

[SkareKrow]

for the rear I actually only swapped the hub and disc, caliper and everything else it the same, you may notice that you gain positive camber on the front end when you use the type s knuckles I just used camber bolts, but this could be also because i still have stock suspension

check that your knucles are not bent.. Even slightly will br a PITA to align.

¶SK¬

[ep3hatchvcp]

I Did the 5 lug type s conversion on my 03 ep i ended up with positive camber on one wheel and negative on the other but rides good and brakes are so much better now

[ep3hatchvcp]

yea 05 06 wont fit in your ep control arms you have to get the type s because the ball joints are bigger i took mine to a shop and had them drill them out since io had an 05 06 conversion

Looks like just a few last parts to by just incase. Not sure if my swap is 02-04 or 05-06 (is there a way to check?)

[Bwek]

no way to really check if they are bent, but both sides had the exact same amount of camber Im just going to assume it is because of stock Ep3 4x4 ride height lol

[Eddie Murphy]

check that your knucles are not bent.. Even slightly will br a PITA to align.

¶SK¬

How can I check to see if the knuckles are bent?

[SkareKrow]

How can I check to see if the knuckles are bent?

find one that is for sure good. Thats the way i figured it out.

Sent from my SPH-L710 using Tapatalk

[Ubeyo]

mine were bent. you can kinda tell they will be completely strait. 90 degree angles. if you have them off or can fit a ruller under it to mesure it line it up and if the lines are crooked its probably bent. i put mine on by wiggling it in there and it had a -3 toe lol thats how i could tell -.-