+1 For RBB
I'm running an 08 k24a2 with a custom 3.5CAI 50gearand couldnt be happier with the RBB.
Just keep in mind there is an RBB v2 version out there from the newer TSXs when they changed the engines in 07. There was a dyno on club tsx comparing the RBB v1 and the RBB v2, and the v2 gave out like 2 more Hp/torque across the entire revband.
heres my 2 cents. dont waste money on a throttle body. in your position i would definitely start with the thermal intake gasket and a CAI. its amazing what cooler air intake temps can do for the power of an engine.
also, i dont know why everyone is so obsessed with the rbc and rbb. im running a port matched/ slightly polished prb on my k24a2 and made 230hp and 205tq. granted it was on a dynapack which is said to read slightly higher than a dynojet. the best part about the prb is that it allows you to run any ep3 air intake. and if your worried about tapping the water port, dont be, it takes 5 minutes.
Well, I found out I have an 05 intake cam in the engine...so, now that opens up plans for the future....Staying NA, what should I save up for(aside from stage 2 cams?) to make the most power I can? These would still need to be upgrades I could install without pulling the engine...
-cams, oil pump...back to RBC again?
edit- got the CAI installed, might move the battery in the future to shorten the tubing. Will install the IMG when I install the 50*VTC enventually...
Last edited by ryboto; 06-29-2013 at 06:35 PM.
I like that in take set up. Can you pm me list of parts and how you did that cai. Thanks! are you using velocity stack type filter.
So, right now I'm looking at some IPS KME 11 cams for sale....should I jump on em? What else would I need for these to work in a stock K24A2? Springs? Retainers? Anything else?
edit- Guess they weren't for sale :( What's the next best thing?
edit- research has led me to SVM, Drag Cartel(DIC or 2.2?), and Prayoonto(Stage 2?)...just not sure which is the best for 50*VTC, and if the 50*VTC is even necessary to make the most power?
Last edited by ryboto; 07-01-2013 at 01:47 PM.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks