'03 ep3 K24a2 swap ?

[Eddie Murphy]

I plan to swap an '06 K24a2 into my '03 ep3.
I have K-Pro.
I want to know if I will be able to keep my bolt-ons:

1 - Skunk2 Pro Series 70mm IM
2 - Hybrid Racing 70mm K Series TB
3 - AEM V2 SRI
4 - OBX Ver2 Race Headers non s-type
5 - A'Pexi Noir ep3 spec catback

Thanks ...

[captaingamez]

You will have to run an adapter plate to use your intake manifold, then you can use your throttle body obviously. the plates are available from quite a few places, actually i think skunk2 sells one. but the k24a2 water inlet is different than the k20a3 and k24a1/a4.

The ram intake should fit well enough, but the race headers you may have to play with, the catback should be fine.

[Eddie Murphy]

Thanks captain.... Can you shoot over a link where to buy that adapter plate?

[Eddie Murphy]

Or tap the head to keep the manifold...???...

[gtecd20]

i got mine from TB adapter from kraftswork for around 100 plus bucks, your intake wont work due to the angle of the IM from the k24 unless u cut it down to make it fit, i thik you need an adapter plate for the sk2 im to bolt on the k24. The OBX v2 should work just like capt said might have to adjust the catback part.
everything else is pretty much bolt on

[Eddie Murphy]

Or tap the head to keep the manifold...???...

[gtecd20]

get the correct manifold to allow correct flow. its not worth it to keep the a3 manifold

[Eddie Murphy]

OK, the manifold and throttle body are 70mm. I want to keep them both and tap the head. Any help on tapping the head would be appreciated. Thanks.

[Eddie Murphy]

I got my answer for tapping the head and keeping my manifold/throttle body here. Thanks.

http://www.ephatch.com/forum/showthr...=1#post1011681

as far as the v2 intake can I use some sort of coupler to keep it?

[danito321]

@eddiemurphy were you able to use the prb mani? I really wanted to use mine but used the rbb instead. Post up what you think.

[T_Virus]

i remember J000stin bought my obx rh vers 2 (ep3 spec) and it fit with his ep3 k24a2 swap with no issues and it did clear his front sway bar too.

[lemonhead228]

Yea the obx v2 will fit for k24 swap. You catback is okay too.. Not sure on the im but karcept sell the tb adopter plate for 70.

[Eddie Murphy]

Thanks lemonhead228 ... I am going to be tapping the head and keeping my manifold/throttle body.