Ok first diy ! Lets this start, if its goes well ill do diy always from what i do!
Tools needed!
*Side cutter plier
*Needle head plier
*Flat head screw driver
*if you use hog rings again (some people use zip ties) you need a hog ring plier and rings
*And lots of patience !
First lets start with rear seats!
You have to remove star screw from the seat belt holder and take it off!
For take off the headrest holder you have pull hard itll come off
And for the lock you have the push the screw driver in from open side and tilt it so it can pop off from the lock!
Last think you have the remove plastic cover off from the back!



Now we can start the remove the cover!
First you have to open the zip
Then open the special plastic seat zip!




And now time to grab the side cutter plier and cut some hog rings! Please be a patient while you removing cover for avoid the rip off your seats!

Now we remove the rear top seats covers off now time to get under seat!
It ll be more easier then the top because it wont be tight as much as tops
You have to flip the rear seat bottom and start cutting the hog rings !
And dont forget any rings between the crack i had 6 ring ! Between each crack!

PS:while you removing this cover from top rear dont forget all the metal clips on plastic ! One of mine still got stuck on the seat i didnt relized it untill almost rip the seat! While i am pulling the cover off!


After removing all the rings , seat cover will be off from the seats :) !
For put the covers back ,you have to grab this bad boy and the ring! and reverse the steps!


And walla!


Sent from my iPhone using Tapatalk