The only information I can give you is that the stock EP3 ABS sensor sits too close to the 36mm DC5-S axles and you have to shim it with some washers.
I have found success with (2) 1/8" thick washers and it PERFECTLY spaces the ABS sensor to the DC5-S axle ABS ring. I haven't measured it with my feeler gauge, but I would say it's about .10"-.12" close.
Hope this info helps, you could possibly measure your stock axle ABS ring and do some math and add the thickness of the washer I used to get a rough estimate of the DC5-S axle.
Bookmarks