hello everone, i just installed dc5 type r rear strut bar with gussets, and the aluminum floor brace. installation was straight forward and fitment are ok, except i run into few problems, want to check with those who have these pieces installed. if its my installation error or thats just how it is.
After installing the rear strut bar with the gussets i am not able to re-install the plastic pieces that cover the shock tower. it seems like the bottom plastic is hitting the strut bar, anyone came across the same issue? does it require trimming to the plastics?
for the aluminum floor bar. the center 4 bolts lined up perfectly, the ends however, only the bolt on each side that is toward the rear were lined up, the front 2 have over an inch gap, and the holes don't line up. i read another thread someone came across the same issue. i want to see if anyone able to get dc5 bracket so all 4 of the end bolts would line up? also after installing the floor brace, i am not able to line up the rear side panels, it seems the brace is hitting the floor bar closer to front seat belts lower bolts. anyone ran into same issue? did you have to trim the plastic?
thanks in advance
Braniff
Reply With Quote
Bookmarks