Close

Results 1 to 3 of 3

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Registered User
    Join Date
    Jan 2018
    Location
    Frisco,Tx
    Posts
    8

    Ep3 ABS sensors on 02 RSX-S knuckles HELP!!!!

    Hello guys, im currently in the process of doing my 5 lug swap on my 03 Si, But im stuck at the ABS sensors. The sensor fits inside the sensor hole, but is too long and it makes contact with the splines on the axle. Ive searched for hours, and out of the few DIY's out there, only one slightly mentions it, but its not the best explanation. Please re-direct me if im not in the right location.

    BTW this is what he mentions "Ep ABS sensors can be reused on type s swap but ABS line MUST be taken off clamp for ABS to allow more slack in the line. clamp should be bent closed and bent back out of the way of the line.
    Washers will also be needed to pull it away from the ABS and keep it from being ground down!"

    Again any help would be appreciated. Thanks!



  2. #2
    Registered User
    Join Date
    May 2019
    Location
    California
    Posts
    32
    That happend to me I need hit the junk yard get new sensors but they used washers to extend the abs bolt

  3. #3
    Registered User
    Join Date
    Jan 2018
    Location
    Frisco,Tx
    Posts
    8
    Dude I just used Type S abs sensors for my Type S knuckles. Saves the hassle of doing the washer mod.

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •