Close

Results 1 to 2 of 2
  1. #1
    Registered User
    Join Date
    Dec 2018
    Location
    Iowa
    Posts
    5

    Clutch Install problems need help!

    So I bought a twin disc clutch for my ep3 after the stage 1 was slipping on the dyno and when trying to install the tranny back onto the engine, the transmisson will not seat flush against the block. There is about a half inch gap between the bell housing and block. replaced pilot bearing which is seated all the way down. Even tried to bolt up the tranny with the clutch discs not installed and still im unable to push the tranny on any further. (yes my dowl pins are lined up). I dont understand what could be preventing the transmission from seating.

  2. #2
    Dope Whore 麻薬中毒の娼婦 dustyboner's Avatar
    Join Date
    Apr 2008
    Location
    nm
    Posts
    106
    only thing i can think of would be a fuct up pilot bushing (bearing).

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •