Anyone knows how to remove the gauge cluster?

[hamproof]

Sorry to be asking the same question again. I can't figure out how to remove the outer plastic bezel thingy in front of the cluster.

Usually that plastic bezel is held in place w/ 2 screws. It is not the case in this Si.

Anyone knows how best to yank out this plastic piece?

[Jpax]

Its like a press fit, you have to press slighty on one corner inside the cluster then out.

I have a full screen video on my Vcd @ my web-site, i added. I need to update the site.

[hamproof]

I didn't mean to imply anything with the arrows. Just pointing out the piece. I tried prying (though not w/ force) it like a sissy on the top but it won't come out. So, you are saying just use more force?

The reason being there's a big gap bet. the plastic protector and this plastic piece I'm trying to remove. I think it was mis-aligned from the factory causing all sort of rattling sound.

[Jpax]

Yes start with the bottom though. then once its loose move up.