The easiest way is to lower the back seats. Lift up the corner of the rug near the outside corner of where the seat sits when upright. There should be a plastic rivet (for lack of the correct term) holding down back corner of the carpet on the seats, as well as the bottom edge of the shock housing. Remove the "rivet" with a screwdriver (be sure to lift the middle part, then the actual rivet). Then put the screwdriver head in the little slot at the top of the shock housing and pop the housing off.and how do you get to the back shock tower, in the hatch, i can't get the panels to pop out?
Getting it back together is just the reverse process, but it takes some work to get the plastic housing to sit flat again. Just get it positioned, then get the front of it pushed fully into place. Then push the back into place and replace the rivet.
Hope that helps.
Bookmarks